- 您现在的位置：买卖IC网 > Sheet目录314 > AUIR2085S (International Rectifier)IC DVR HALF-BRDG SELF OSC 8SOIC
AUIR2085S
Pin Descriptions
Cs: The input pin to the overcurrent comparator. Exceeding the overcurrent threshold value specified in
“Static Electrical Parameters” Section will terminate output pulses and start a new soft start cycle as soon as
the voltage on the pin reduce below the threshold value.
OSC: The oscillator-programming pin. Only two components are required to program the internal oscillator
frequency: a resistor connected between the V CC pin and the OSC pin, and a capacitor connected from the
OSC to COM. The approximate oscillator frequency is determined by the following simple formula:
f OSC = 1 / (2 · R T · C T )
Where frequency is in Hertz (Hz), RT resistance in Ohms ( ? ) and CT capacitance in Farads (F). The
recommended range of timing resistors is between 10k ? and 100k ? and range of time capacitances is
between 47pF and 470pF. The timing resistors less than 10k ? should be avoided. The value of the timing
capacitor determines the amount of dead time between the two output drivers: lower the CT, shorter the
dead time and vice versa. It is not recommended to use a timing capacitor below 47pF, for best performance
keep the timing components physically as close as possible to the AUIR2085S. Separated ground and V CC
traces to the timing components are encouraged.
COM: Signal ground and power ground for all functions. Due to high current and high frequency operation, a
low impedance circuit board ground plane is highly recommended.
HO, LO: High side and low side gate drive pins. The high and low side drivers can directly drive the gate of a
power MOSFET. The drivers are capable of 1A peak source and sink currents. It is recommended that the
high and low drive pins be very close to the gates of the high side and low side MOSFETs to prevent any
delay and distortion of the drive signals.
V B : The high side power input connection. The high side supply is derived from a bootstrap circuit using a
low-leakage Schottky diode and a ceramic capacitor. To prevent noise, the Schottky diode and bypass
capacitor should be very close to the AUIR2085S.
V S : The high side power return connection. V S should be connected directly to the source terminal of high
side MOSFET with a trace as short as possible.
V CC : The IC bias input connection for the device. Although the quiescent V CC current is very low, total supply
current will be higher, depending on the gate charge of the MOSFETs connected to the HO and LO pins, and
the programmed oscillator frequency, total V CC current is the sum of quiescent V CC current and the average
current at HO and LO. Knowing the operating frequency and the MOSFET gate charge (Qg) at selected V CC
voltage, the average current can be calculated from:
Iave = 2 x Qg X f OSC
To prevent noise problem, a bypass ceramic capacitor connected to V CC and COM should be placed as
close as possible to the AUIR2085S.
AUIR2085S has an under voltage lookout feature for the IC bias supply, V CC . The minimum voltage required
on V CC to make sure that IC will work within specifications must be higher than 8.5V (10V minimum V CC is
recommended to prevent asymmetrical gates signal on HO and LO pins that are expected when V CC is
between 7.5V and 8.5V).
www.irf.com
11
? 2008 International Rectifier
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
AUIRS2003S
IC DRVIER HALF-BRIDGE 8SOIC
AUIRS2004S
IC DRVIER HALF-BRIDGE 8SOIC
AUIRS2112S
IC DRIVER HIGH/LOW SIDE 16SOIC
AUIRS2113S
IC DRIVER HIGH/LOW SIDE 16SOIC
AUIRS2118S
IC DRIVER HIGH SIDE SGL 8SOIC
AUIRS2123S
IC DRIVER HIGH SIDE 600V 8SOIC
AUIRS2127STR
IC DVR CURRENT SENSE 1CH 8SOIC
AUIRS21811S
IC DRIVER HIGH/LOW SIDE 8SOIC
相关代理商/技术参数
AUIR2085STR
功能描述:功率驱动器IC 100V AUTO GRADE HI SPEED 500kHz RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
AUIR3200S
功能描述:功率驱动器IC High side mosfet TEMP protection
RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
AUIR3200STR
制造商:International Rectifier 功能描述:HIGH SIDE MOSFET DRIVER WITH SHORT CIRCUIT AND TEMPERATURE P - Tape and Reel 制造商:International Rectifier 功能描述:IC MFET DRVR HIGH SIDE 8SOIC 制造商:International Rectifier 功能描述:T&R / High side mosfet driver with short circuit and temperature protection
AUIR3240S
功能描述:功率驱动器IC Low Quies. Curr Gate Driver 75V 50A, Auto
RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
AUIR3240STR
功能描述:功率驱动器IC Low Quies. Curr Gate Driver 75V 50A, Auto
RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
AUIR3241STR
功能描述:IR_HSS-LSS-GATEDRIVER 制造商:infineon technologies 系列:* 零件状态:在售 标准包装:2,500
AUIR3313
功能描述:功率驱动器IC AUTO PRGM CURRENT SENSE HI SIDE SWITCH RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
AUIR3313S
功能描述:功率驱动器IC AUTO PRGM CURRENT SENSE HI SIDE SWITCH RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube